How to Measure Your Dog for a Harness (Without the Guesswork)
How to measure your dog's chest girth and neck for a harness, read a size chart, and check the fit at home, step by step.
- By
- Sajime
- Published
- Reading time
- 4 min
DisclosureWe may earn a commission when you buy through links on this site, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.

To measure your dog for a harness, wrap a soft tape measure around the widest part of their chest, just behind the front legs. That’s the chest girth, and it’s the number most harness size charts use. Many brands also ask for the neck, measured around the base of the neck, lower than where a collar sits. Write both down, then compare them with that brand’s own chart, because sizes aren’t the same from brand to brand. Weight alone is a rough guide at best.
What you need
- A soft tape measure (the bendy sewing kind). No tape? Use a piece of string, mark it with a pen, then measure the string against a ruler.
- A few small treats, so measuring feels like a game.
- A helper if your dog is wiggly. One person feeds treats, the other measures.
Step 1: Measure the chest girth
- Have your dog stand on all four legs. If they sit or lie down, the number comes out wrong.
- Find the widest part of the ribcage. For most dogs that’s just behind the front legs.
- Wrap the tape all the way around, flat against the body. It should be snug but not squeezing.
- Read the number where the tape meets, then measure once more to be sure.
Step 2: Measure the neck
Not every chart asks for this, but many do. Measure around the lower neck, where it meets the shoulders. That’s usually lower than where a regular collar sits, so don’t just use your dog’s collar size.
Step 3: Weigh your dog (as a backup)
Some brands add a weight range next to each size. It’s a helpful sanity check, but two dogs that weigh the same can have very different chests. A deep-chested sighthound and a stocky bulldog type are a good example. Go by the measurements first.
Step 4: Read the brand’s size chart
This is where most sizing mistakes happen. A medium from one brand can be a small or a large from another. Here’s how a few brands put it on their own pages:
| Brand | What their sizing is based on | Their advice between sizes |
|---|---|---|
| Ruffwear (Front Range) | Chest girth, XXS 13-17 in up to L/XL 32-42 in | Check Ruffwear’s fit guide |
| PetSafe (Easy Walk) | Girth, eight sizes from Petite (12-17 in) to Extra Large (32-49 in) | Size up |
| 2 Hounds Design (Freedom) | Chest, XXS 13-16 in up to XXL 36-44 in | Pick the smallest size that fits |
| Blue-9 (Balance) | Girth, on its own size chart, Extra Small to Large | Choose the larger size when in doubt |
Size ranges and advice are from each brand’s product page or size chart, checked in November 2026. Notice that PetSafe and Blue-9 say to size up, while 2 Hounds says to go with the smallest size that fits. That’s why it pays to read the advice for the exact harness you’re buying.
Step 5: Check the fit once it arrives
Put the harness on indoors, adjust it, then run through this quick check:
- The two-finger test. You should be able to slip two fingers under each strap. Blue-9 and 2 Hounds Design both give this rule.
- Nothing in the armpits. The strap around the body should sit on the ribcage. Blue-9’s fitting guide warns that a girth strap sitting too far forward can chafe the armpits.
- No twisting. Walk your dog around the room. If the harness slides to one side, tighten the loose strap a little.
- No escape route. If your dog can back out of it with a little wiggle, it’s too loose.
- Front clip in the right spot. On a no-pull harness the front ring should sit on the chest, not hang down low between the legs.
Signs the harness doesn’t fit
- Red skin, hair loss or rubbing behind the front legs
- Your dog walks stiffly or seems to move differently with it on
- Straps that leave deep marks after a walk
- A harness that rides up toward the throat when your dog pulls
If you notice any of these, re-adjust or try another size or style. If your dog seems sore, or has joint or breathing problems, ask your vet before you pick a harness. And if pulling is the real issue, remember a harness only helps you manage it: a certified trainer can help you work on the habit itself.
Common measuring mistakes
- Measuring over a fluffy coat too loosely. Press the tape gently through the fur so you get the real body size.
- Using the collar size for the neck. Harness neck straps usually sit lower and need a bigger number.
- Measuring a sitting dog. The chest changes shape when your dog sits.
- Trusting “medium” across brands. Always use the chart for the harness you’re buying.
Ready to choose?
Once you have your numbers, have a look at our best no-pull dog harnesses, where we compare leash points, padding and sizing for six popular picks.
Ruffwear Front Range Harness
A padded everyday harness with two leash points. Ruffwear lists reinforced webbing at the chest for dogs that pull, an aluminum V-ring on the back for relaxed walks, four adjustment points, an ID pocket and reflective trim.
- Leash attachments
- 2 - reinforced webbing on chest, aluminum V-ring on back (per Ruffwear)
- Adjustment points
- 4 (per Ruffwear)
- Padding
- Foam-padded construction, PE foam (per Ruffwear)
Want more? See all our harness and leash guides.